Artnet 2 Twinkly 3.16.0.0 Changelog

A new major feature warrants a new major version but that's not all we did.

enhancements:

--Added DMX Mode (beta)-paywalled but unlocked until march 1st. It's beta after all.

--Treeview no longer has blocking code on the same thread. It could still take

a minute to load a giant model but you can switch away from that device now.

bugfixes:

--some buttons were anchored wrong on the editor window which screwed up their position when you resized it.

--there was a bug in the 3d exporter that affected large models. The z-order would rollover, mixing the layers. This did not affect all models and you may have never seen it happen.

--XModel export specifically was one square too wide.

--When using "auto-start streaming" the button didn't reflect you were in streaming mode. Fixed.

--submodels weren't displaying properly in the preview.

--rolling "advanced" testmode was broken if you were logged in.

--The preview window wasn't properly refreshing when you shut streaming off

--The "Allow one pro device while unlicensed" had a math error and was allowing 0 pro devices. Oops.

--prevent a rare crash when switching windows while on the edit screen

--Auto-set channels was failing in some cases. I think it was from the ui not drawing fast enough and it happened when there were multiple groups in a row in the list. It's now running on a non-ui thread.

changes:

--Lowered the preview framerate again. It was getting bogged down on huge models.

--treeview was unnecessarily refreshing when not receiving data when live output was checked.

--exporter has had some controls colors changed to system colors so it is still readable with various themes. This is not across the board and some stuff is still hard to read.

--Exporter had some ineffecient code refactored. It is faster and will use less memory.

--Editor loads large models much faster. example: 5 sec vs 12 sec.

--Autoset channels no longer makes you confirm groups.